2-component sealing with high mechanical and chemical resistance
- solvent based
- protection against environmental impact and stains
- freeze-thaw resistance is improved
- mixing ratio: 8 parts by weight comp. A: 1 part by weight com. B
- resistant against chemicals, liquid-tight and high mechanical load capacity
The surface must be load-bearing, dry (residual moisture <5 % CM-method), clean and free of grease and oil.
Article number250452
Last update11/10
Handling HintsREBAtex AC is applied uniformly with a paint brush/roll or an appropriate spray system. Prior to application stirr comp. A well. Add comp. B completely to comp. A and mix homogeneously with a slow-speed stirring device (approx. 300 rpm).
The mixed material should be filled into a clean bucket and mixed again shortly. REBAtex AC can be applied again after approx. 5 min. (approx. 40 °C hot air).
FormComp. A: liquid; Comp. B: liquid
The specified quantities are approximate values because the actual applied quantity does not only depend on the surface structure, but also on the absorbency of the surface.
ConsumptionPrimer (if necessary): approx. 150 – 250 g/m²
Sealing: approx. 200 g/m² StorageProtect against frost and dirt. Under normal storage conditions (closed container, 20 °C) minimum shelf-life 6 months. Prior to use, stirr comp. A well. Protect comp. B against air humidity. PackagingTwo-in-one-can: 10 l
Two-in-one-can: 1 l « back
Sealing: approx. 200 g/m² StorageProtect against frost and dirt. Under normal storage conditions (closed container, 20 °C) minimum shelf-life 6 months. Prior to use, stirr comp. A well. Protect comp. B against air humidity. PackagingTwo-in-one-can: 10 l
Two-in-one-can: 1 l « back
Applicationscement-bonded surfaces
high-quality concrete products ColorComp. A: yellowish; Comp. B: colourless DensityComp. A: 0.96 ± 0.02 g/ml; Comp. B: 1.07 ± 0.02 g/ml InspectionSuitable preliminary tests are required!
During application and hardening the object temperature should at least be +8 °C. The processing time at room temperature is approx. 72 hours in closed containers.
high-quality concrete products ColorComp. A: yellowish; Comp. B: colourless DensityComp. A: 0.96 ± 0.02 g/ml; Comp. B: 1.07 ± 0.02 g/ml InspectionSuitable preliminary tests are required!
During application and hardening the object temperature should at least be +8 °C. The processing time at room temperature is approx. 72 hours in closed containers.
